Specifies the directory where Setup is to copy its temporary files. Load the specified Setup.inf file when starting setup. Specifies the source directory where the Windows 98 Setup files are located. The setup script file name must be eight characters long with a three-character extension (8.3 file name). Use settings in the specified script to install Windows 98 automatically for example, setup msbatch.inf specifies that Setup should use the settings in Msbatch.inf. Load Advanced Configuration and Power Interface (ACPI) by default. By default, Setup removes the forced configuration and some hardware does not work properly after this is done. Some BIOS require hardware to have a forced configuration to work. Keep forced configured hardware settings (hardware not using default settings). Same as if there is a "BootCD=1" line in the Msbatch.inf fileĭo not run Hwinfo.exe when running Setup from the Windows 95 user interface.īypass the check for minimum processor (66MHz 486)Ĭopy a minimal installation of the required dynamic-link libraries (DLLs) used by Windows 98 Setup, then exit to MS-DOS without installing Windows 98.ĭo not check the version of Setupx that is running. Same as if there is a file named BOOTCD in the cabinet folder Use this switch when installing Windows 98 from a booTABLE compact disc. inf file still force Windows 98 Setup to keep the newer files.ĭo not prompt to remove the floppy disk from drive A at the end of the Copying Windows 98 Files to Your Computer Setup step (step three). Note: Files that use the ",32" flag in the. This switch ignores the presence of a Migration.dll file and is used to force Windows 98 to overwrite newer files. #= 3 No Windows-based or MS-DOS-based program check. #= 2 No MS-DOS-based program check, Windows-based programs are blocked. #= 1 No Windows-based program check, but MS-DOS-based program are blocked. This switch bypasses the program check and can use the following values: This switch causes Setup to run without a mouse. This switch bypasses displaying the Setup screens during an upgrade within Windows.īypasses the playing of the Setup sound (.wav) files. Neither the networking software nor the Networking Wizard screens will be used.ĭo not update the master boot record (MBR). Skip the check for low conventional memory.ĭo not call the networking Setup software. Use this option if you have a Logitech Series C mouse. Use this switch if the system stalls during the ScanDisk check or if an error results. Run ScanDisk in the foreground so that you can see the results. Do not notify setupx DOS FindFirst to not look up file names in the cache.Īllows Setup to run on some older Gateway and Micron computers with an early BIOS. If this switch is used, the Windows\Command\EBD folder is not created.ĭo a "fast" setup. If this is set and KeepRMDrivers=1 is not in the registry, drivers are commented out from the Config.sys/Autoexec.bat file.ĭo not check for the minimum disk space required to install Windows 98. Turn off the "before providers" listed in the section of the Setupc.inf file.ĭo a clean boot. Turn off the "after providers" listed in the section of the Setupc.inf file. Setup runs a little slower and saves a small amount of memory. Set the Windows NT Logon Validation domain used by Client for Microsoft Networks to domain _name.ĭo not look in the local cache for file names. Use this switch if you have problems starting Setup that might be due to missing or damaged supporting files for Windows Provides help for syntax and use of setup command line switchesĭo not use the existing version of Windows for the early phases of Setup. Setup Command-Line Switches By: Arie Slob Windows 98 > Getting Started With Windows 98
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |